can’t read the following volume file

If you want to contribute to Partimage, please post there

Moderator: feffer

Post Reply
gln1054
Posts: 1
Joined: Mon Feb 09, 2009 8:11 pm

can’t read the following volume file

Post by gln1054 » Mon Feb 09, 2009 8:22 pm

Downloaded SYSLINUX and installed it on a 8gig USB flash drive (fat32).
Re-named the .CFG file and made the drive bootable, as per the instructions.

Rebooted my dell desktop and changed the boot sequence to boot off the USB.
Ran the ping image back up and acquired the image files listed below.
F:\bridgemac\bios
F:\bridgemac\HDD_Look.txt
F:\bridgemac\sda
F:\bridgemac\sda1.first_sectors
F:\bridgemac\sda2.first_sectors
F:\bridgemac\sda1.000
F:\bridgemac\sda1.001
F:\bridgemac\sda1.002
F:\bridgemac\sda1.003
F:\bridgemac\sda1.004
F:\bridgemac\sda1.005
F:\bridgemac\sda1.006
F:\bridgemac\sda1.007
F:\bridgemac\sda1.008
F:\bridgemac\sda1.009
F:\bridgemac\sda1.010
F:\bridgemac\sda3.first_sectors
F:\bridgemac\sda2.000
F:\bridgemac\sda2.001
F:\bridgemac\sda2.002
F:\bridgemac\sda4.first_sectors
F:\bridgemac\sda5.first_sectors
F:\bridgemac\sda5.000

Booted with the USB and ran “partimage” on the other machine. Everything that I would expect to see, all the partitions on the other drive I want to image to and the fat32 drive I want to take the image from.
However when trying to restore the image I only see “can’t read the following volume file” I have tried numerous variations of \bridgemac, /bridgemac, F:\bridgemac.
So far no luck. I just know that I am missing something simple.

Any suggestions would be greatly appreciated.

Post Reply